【廣告】
在電機與減速機連接前,應先將電機軸鍵槽與緊力螺栓垂直。為保證受力均勻,先將任意對角位置的安裝螺栓旋上,但不要旋緊,再旋上另外兩個對角位置的安裝螺栓后逐個旋緊四個安裝螺栓。
Before connecting the motor to the reducer, the key slot of the motor shaft should be perpendicular to the tightening bolt first. To ensure uniform force, screw the mounting bolts at any diagonal ition first, but do not tighten them. Then screw the mounting bolts on the other two diagonal iti, and tighten the four mounting bolts one by one.
減速機與工作機的聯接:減速機直接套裝在工作機主軸上,當減速機運轉時,作用在減速機箱體上的反力矩,又安裝在減速機箱體上的反力矩支架或由其他方法來平衡。機直接相配,另一端與固定支架聯接.
The connection between the reducer and the working machine: the reducer is directly installed on the main shaft of the machine, when the reducer operates, the torque acting on the gearbox body is installed on the reverse torque support on the reduction box body or by other methods to balance. The machine is directly matched and the other end is connected with the fixed support.
減速機內部齒輪寬度 在減速機傳動空間允許時,增加齒輪寬度,可以減少恒定扭矩下的單位負荷。降低輪齒撓曲,減少噪聲激勵,從而降低傳動噪聲。
The width of the internal gear of the reducer can be increased when the transmission space of the reducer is allowed, so that the unit load under ctant torque can be reduced. Reduce gear deflection, reduce noise excitation, thereby reducing transmission noise.