旋緊緊力螺栓。所有緊力螺栓均需用力矩板手按標明的固定扭力矩?cái)?shù)據進行固定和檢查。減速機與機械設備間的正確安裝類同減速機與驅動電機間的正確安裝。關鍵是要必須保證減速機輸出軸與所驅動部分軸同心度一致。

Tighten tight bolt. All tight bolts must be fixed and checked with the fixed torque data marked by the torque plate hand. The correct installation between the reducer and the mechanical equipment is the same as that between the reducer and the driving motor. The key is to ensure that the output shaft of the reducer is cistent with the of the drive shaft.

通常齒輪減速機已廣泛應用于冶金、礦山、起重、運輸、水泥、建筑、化工、紡織、印染、制藥、等領域。但在這種齒輪減速機的使用有一定的限制,所以,讓我們了解下使用時需要注意什么。

1、高速旋轉不超過1500 r / min。齒輪減速器。

2、齒輪圓周速度不超過20 m / s。

Usually gear reducer has been widely used in metallurgy, mining, lifting, transportation, cement, ctruction, chemical, textile, printing and dyeing, pharmaceutical, and other fields. But there are some restricti on the use of this gear reducer, so let us know what to pay attention to when using it.

1. The high speed rotation does not exceed 1500 R / min. Gear reducer.

2, the circumferential speed of the gear is not more than 20 m / S.

減速機內部齒輪精度等級 設計減速機時，設計者往往從經濟因素考慮，盡可能比較經濟的確定齒輪精度等級，忽略精度等級是齒輪產生噪聲與側隙的標記。

When the reducer is designed in the gear precision grade of the reducer, the designers often cider the economic factors as much as  to determine the gear precision level as much , and ignore the precision grade as the mark of the gear noise and the backlash.