切分刀粘鋼是如何引起的？（1）切分孔型老化，切分孔出來的料在切分契尖處較厚，增加了切分刀的切分負荷；（2）切分道和孔型不對中，使切分刀不能順利切開料型，引起粘鋼；Rollingistheprocessofchangingthepressureoftheingotandtheshapeofthebilletbetweentherotatingrolls。（3）切分處冷卻水冷卻效果不好，導致粘鋼；（4）料型控制不好，或有條頭和開花頭現象，使切分刀不能順利切開料型。

How does the slitting tool stick to the steel?

(1) the slitting hole is aging. The cutting hole is thicker at the cut point and the cutting load is thicker. (2) the cutting section and the pass are not in the middle, so that the cutting tool can not cut the material well and cause the sticky steel. (3) the cooling effect of the cooling water is not good, and (4) the  of the material type is not good, or there is a strip head and the flower head phenomenon, so that the cutting knife can't go smoothly. Cut the material type.

所謂低溫?zé)彳埵侵干愿哂谠俳Y(jié)晶溫度下的軋制。提高軋制溫度可以降低軋件溫度的屈服應力，使變形功降低。但是由于變形功可以轉化為熱量，因此，當軋件溫度的熱損失主要是熱輻射時，熱損失量與軋件溫度的4 次方成正比。

The so-called low temperature hot rolling is a rolling that is slightly higher than the recrystallization temperature. Increasing rolling temperature can reduce yield stress of workpiece and reduce deformation work. However, the deformation work can be converted into heat, so when the heat loss of the rolling temperature is mainly heat radiation, the amount of heat loss is proportional to the 4 time of the rolling temperature.

軋鋼機在市場中的成長特別注重對自身品質的塑造。并且在市場中也需要品質軋鋼機械來裝飾，只有這樣在能塑造出一個良性發展的市場環境，才能令自身在這樣的良性發展的環境中成長的更加的快速。

The growth of rolling mills in the market pays special attention to the shaping of their own quality. And in the market also needs excellent quality steel rolling machinery to decorate, only in this way can create a benign development of the market environment, to make itself in such a benign development of the environment to grow more fast.